Delete a route
You can delete a route by selecting the Delete menu option when
the route is activated. You can also delete routes from the Routes
tool on the Home page.
Autorouting and Easy Routing
The Autorouting and Easy Routing suggest new routepoint
positions based on information in the map and on your boat's size.
Before you can start using this feature the boat draught, width and
height must be entered into the system. The boat settings dialog is
automatically displayed if the information is missing when you start
the feature.
Ú
Note: GO7 units designed for sale in the U.S. region do not
have Autorouting or Easy Routing capabilities. Autorouting
or Easy Routing features are disabled on all non-U.S. units
when they are used in U.S. territorial waters.
Ú
Note: It is not possible to start the Autorouting or Easy
Routing if one of the selected routepoints is located in an
unsafe area. A warning dialog is displayed, and you have to
move the relevant routepoint(s) to a safe area to proceed.
Ú
Note: If no compatible cartography is available, the
Autorouting or Easy Routing menu option is not available.
Compatible cartography includes Jeppesen CMAP MAX-N
+, Navionics+ and Navionics Platinum. For a full selection of
available charts please visit insightstore.navico.com, c-
map.jeppesen.com or navionics.com.
1. Position at least two routepoints on a new route, or open an
existing route for editing.
2. Select Autorouting, followed by:
- Entire Route if you want the system to add new routepoints
between the first and the last routepoint of the open route.
- Selection if you want to manually select the routepoints that
define the limits for the autorouting, then select the relevant
routepoints. Selected routepoints are colored red. Only two
routepoints can be selected, and the system discards any
routepoints between your selected start and end points.
3. Select Accept to start the automatic routing.
Waypoints | GO7 Operator Manual
45
To Next Page
Loading...
Need help?
General
