6
Optional Tray
Installation
After installing the machine, make sure the following before installing the Optional Tray:
Power off the machine
Pull the power cord off the machine and unplug all the cables at the rear side.
1. Remove all the packaging material and tapes on the tray support
2. Pull out the feed unit
3. Hold the both ends of the support and place it where the machine is installed.
4. Re-install the feed unit. Push it to fit into the machine.
5. Lift up the machine by holding the dented handles at both bottom sides and place it
where it will be installed on. Align the taps, narrow slit and connectors on the tray to the
bottom side of the machine correctly. Place the machine onto the tray and make sure of
the correct match again.
To Next Page
Loading...
