Sindoh M612 - Page 175

169
스캐너부 용지 걸림 메시지
메시지
설명
201 Scanner Jam
The problem occurs when the leading edge of the original does
not arrive at the 1st scan sensor within a specified time.
1. Check if there is any foreign substances on ADF paper path.
2. Check if the pickup roller works normally.
3. Check if the 1st scan sensor works normally.(inspection
mode)
4. Replace the sensor and test it again if it works abnormally.
202 Scanner Jam
The problem occurs when the leading edge of the original does
go past the 1st scan sensor within a specified time.
1. Check if there is any foreign substances on ADF paper path.
2. Check if there is any remaining paper around ADF exit roller.
3. Check if the 1st scan sensor works normally.(inspection
mode)
4. Replace the sensor and test it again if it works abnormally.