Sintratec S1 - Technical data; Printing performance; Specifications for powder

Technical data
20 / 76 Sintratec S1 BA_S1_en 1.1
Pos: 76 /docuglo be CE-Expert/Ü berschriften/1. Ebene/Technisc he Daten @ 0\ mod_141 4506774559_6556 .docx @ 6573 @ 1 @ 1
4 Technical data
Pos: 77 /Sintrat ec/Kap./Technisc he Daten/Tec hnische Daten S 1 @ 3\mod _146398144066 2_6556.docx @ 8912 @ @ 1
Dimensions (height x width x depth)
755 mm x 670 mm x 368 mm
Unladen weight
Approx. 65 kg
Dimensions (height x width x
depth)/Volume of powder container
200 mm x 225 mm x 150 mm; 6.75 dm
3
Dimensions (height x width x
depth)/Volume of print container
200 mm x 150 mm x 150 mm; 4.5 dm
3
Rated current (fuse protection rating)
8 A
Supply voltage
230 VAC
Frequency
50 Hz
Protection class
IP31
Laser power
2.3 W
Laser wavelength
445 nm
Class of laser source
4
Sound level
< 70 db(A)
Temperature range for operation (room
temperature)
10 °C - 30 °C
Relative humidity in room
< 70 %
Standby power consumption
Approx. 30 W
Note
In standby mode, the fans for cooling the electronics continue to run.
To reduce the power consumption, it is recommended to fully deactivate the
device via the main switch after it has cooled down.
Pos: 78 /Sintrat ec/Kap./Technisc he Daten/Printl eistung S1 @ 3\ mod_146608 5614439_655 6.docx @ 9508 @ 2 @ 1
4.1 Printing performance
Pos: 75 /Sintrat ec/Kap./Technisc he Daten/Tec hnische Daten @ 3\mod_146 3981440662_ 6.docx @ 8910 @ @ 1
Max. dimensions of print object
(height x width x depth
130 mm x 130 mm x 180 mm
Max. volume of print object
3.04 dm
3
Laser scanning speed
500 mm/s
Pos: 79 /Sintrat ec/Kap./Technisc he Daten/Spezifi kation Pul ver @ 3\mod_14 66144455267_ 6556.docx @ 9 522 @ 2 @ 1
4.2 Specifications for powder
Sintratec PA 12 Black powder is used; see safety data sheet in appendix.
Note
As well as the type of powder stated here, other types of powder can be used or
can be acquired from Sintratec.
The suitability of a powder type can be tested by carrying out trials; here
consultation with Sintratec is recommended.
Pos: 80 /Sintrat ec/++++++++ S eitenumbruch +++ +++++ @ 3 \mod_1463981 070991_0.doc x @ 7762 @ @ 1