Operation
Sintratec S1 BA_S1_en 1.1 47 / 76
8. To accept the correction factors, press the "Send scaling to S1" button.
9. If required, produce another sample print object, check it and repeat the
calibration procedure.
Note
If the optimum digital re-calibration settings have been found, it is recommended
to make a note of these, to be on the safe side. Although the values are saved in
the device, it is possible for these to be lost under certain circumstances.
Pos: 150 /Sintratec /Kap./Betrie b/Restpulver aufb ereiten @ 3\ mod_1466429 919961_6556.d ocx @ 9623 @ 2 @ 1
7.4 Treating the residual powder
Residual powder that accumulates during the printing process can be treated and
then re-used. Residual powder should be used only when mixed with new powder,
to ensure that optimum results are achieved.
1. Sieve the residual powder, so that impurities (caked particles) can be removed.
Use a Mesh 100 sieve (mesh size: 150 μm) for this purpose.
2. Add the residual powder to new powder and mix it in.
Recommended mixing proportions:
max. 30% residual powder and min. 70% new powder (Sintratec PA 12 Black)
– Mix well, so that a homogeneous distribution of residual powder and new
powder is achieved.
Pos: 151 /Allge mein/+++++++++ +++ Neues Kapi tel +++++++++ +++ @ 0\ mod_1414754200 269_0.docx @ 6973 @ @ 1
To Next Page
Loading...