Sintratec S1 - Personal Protective Equipment; Action in Case of Faults and Problems

Faults and problems
60 / 76 Sintratec S1 BA_S1_en 1.1
Pos: 199 /Sintratec /Kap./Wartung/ Persönliche Sch utzausrüstung @ 3\mod_1 46607778507 9_6556.doc x @ 9489 @ 3 @ 1
9.1.1 Personal protective equipment
Use personal protective equipment when carrying out maintenance tasks or tasks
of a similar nature.
Protective laser goggles
Always to be used when maintenance work on open laser unit is
performed. No such work can be done without the approval of the
manufacturer and a recommendation or delivery of appropriate laser
googles.
Respiratory protection
Always to be used when handling powder.
Protective goggles
Always to be used when handling powder.
Hand protection
Latex gloves are always to be used when handling powder.
Suitable work gloves are to be used when handling the device while
this is still hot, or to prevent cuts.
Pos: 200 /Sintratec /Überschrift en/2. Ebene/U - W/Verhalte n bei Störungen und Problemen @ 3\mod_1463 981258846_6 556.docx @ 85 06 @ 2 @ 1
9.2 Action in case of faults and problems
Pos: 201 /Sintratec /Kap./Störung en/Verhalten bei Störungen und Problemen @ 3 \mod_1466 492482428_6 556.docx @ 9637 @ @ 1
Note
For certain faults and problems, "Sintratec Central" provides information on the
fault/problem and on possible solutions.
The FAQ area of the Sintratec Academy provides solutions for various types of
problems.
Make use of the support of Sintratec for faults and problems which you cannot
rectify yourself. Support can be received via our Customer Portal in the
Sintratec Academy.
The following generally applies:
1. In case of incidents where there is an immediate risk of injury to persons or
damage to property, deactivate the device immediately and disconnect it from
the mains.
2. Determine the cause of the fault.
3. Have suitable authorised personnel rectify the fault, according to the type of
fault.
Pos: 202 /Allge mein/+++++++++ +++ Neues K apitel ++++++++ ++++ @ 0\ mod_1414754200 269_0.docx @ 6973 @ @ 1