Sintratec S1 - Removing the print object and performing finishing work

Operation
44 / 76 Sintratec S1 BA_S1_en 1.1
• Cooling
During the final stage of the printing process, the print object is completely covered
in powder, to ensure uniform cooling. The temperature in the device is then
gradually lowered until it is safe to remove the print object.
Once the device switches to the idle mode, the printing process is complete.
4. Set the "Enable laser" key switch to OFF (white lamp goes out).
5. Use the ON/OFF button to switch off the device (indicator lamp goes out).
The device switches to the standby mode.
6. Move the main switch to the OFF position (after the device has cooled down
fully, provided it is not needed again immediately, or whenever cleaning tasks
are to be carried out).
Pos: 146 /Sintratec /Kap./Betrie b/Printobjekt entl aden und nach bearbeiten S1 @ 3\mod_ 1466157812532_65 56.docx @ 9 576 @ 3 @ 1
7.3.6 Removing the print object and performing finishing work
WARNING
Prior to removing the print object, ensure that
• the cooling process has finished and the device is in idle mode.
• the "Enable laser" key switch is in the OFF position.
Use respiratory protection, protective goggles and protective gloves.
1. Empty the print container.
– In the print container, extract by suction as much of the powder surrounding
the object as possible (if a vacuum cleaner for the powder is available), or
else use a scoop to remove this powder, and pour it into a clean container.
– Remove the print object from the print container.
– Remove the rest of the powder from the print container, either with a
vacuum cleaner or with a scoop, and pour it into a clean container.
Note
To facilitate matters, the platform in the print container can be raised
in steps (where, to this end, the "3. Powder" tab is to be selected in
"Sintratec Central"). The door must be closed while doing this,
however.
2. Clean the print object: Remove any powder that is attached with a brush or with
compressed air inside a compressed-air cabin.
Pos: 147 /Sintratec /+++++++ + Seitenumbruch ++++ ++++ @ 3\ mod_146398 1070991_0.docx @ 7762 @ @ 1