Sintratec S1 - Installation and start-up; Safety; Interim storage

Installation and start-up
28 / 76 Sintratec S1 BA_S1_en 1.1
Pos: 96 /Sintrat ec/Überschrifte n/1. Ebene/Inst allation und Inbe triebnahme @ 3\mod_14640 07586377_65 56.docx @ 930 0 @ 1 @ 1
6 Installation and start-up
Pos: 97 /Sintrat ec/Überschrifte n/2. Ebene/Q - T/Sicherheit @ 3\mod_14639 81241743_65 56.docx @ 8421 @ 2 @ 1
6.1 Safety
Pos: 98 /Sintrat ec/Warnhinweise/V ORSICHT - Verletzungsgefa hr/VORSICHT - Hohe Last @ 3\mod_1466 143881617_6 556.docx @ 951 8 @ @ 1
CAUTION
High load
Improper lifting can lead to injuries. Take into account the weight of the device (see
"Technical data" section).
– Have device lifted by two persons only.
– Alternatively, use suitable lifting equipment to lift device.
Pos: 99 /Sintrat ec/Überschrifte n/2. Ebene/X - Z/Zwischenlageru ng @ 3\ mod_1463981272 287_6556.doc x @ 8611 @ 2 @ 1
6.2 Interim storage
Pos: 100 /Sintratec /Kap./Lageru ng/Zwischenlag erung S1 @ 3\mod_14639 81496292_65 56.docx @ 8960 @ @ 1
In case the device is not installed immediately and therefore has to be stored
temporarily, it is beneficial to store it in its original packaging and in compliance
with the following storage conditions:
Pos: 101 /Sintratec /Kap./Lageru ng/Lagerungs bedingungen @ 3\ mod_146 9005235533_655 6.docx @ 10 328 @ @ 1
Storage conditions
Room
Dry, protected against rain
Room temperature
10 - 40 °C
Rel. humidity
< 70 %
Large variations in temperature are to
be avoided
Condensation is to be avoided
Pos: 102 /Sintratec /+++++++ + Seitenumbruch ++++ ++++ @ 3\ mod_146398 1070991_0.docx @ 7762 @ @ 1