Sintratec S1 - Cleaning the working section; Cleaning the inspection glass in the door

Cleaning and servicing
Sintratec S1 BA_S1_en 1.1 53 / 76
Pos: 178 /Sintratec /Kap./Reinigung & Instandh altung/Arbeitsra um reinigen @ 3\mod_1466058 958501_6556. docx @ 944 8 @ 3 @ 1
8.2.6 Cleaning the working section
NOTICE
If the device is cleaned with compressed air, powder can enter the electronics
section or the drive units, which can lead to malfunctions.
Do not use compressed air to clean the device.
Suitable cleaning equipment:
• Vacuum cleaner for powder
• Small brushes
• Cloths
1. Open the door.
2. Remove and clean the excess powder container and the collecting tray.
3. Clean the working section.
4. Place the excess powder container and the collecting tray back in the
device.
Pos: 179 /Sintratec /Kap./Reinigung & Instandh altung/Sichtfens ter in Tür reinig en @ 3\mod_1 46605949823 2_6556.doc x @ 9453 @ 3 @ 1
8.2.7 Cleaning the inspection glass in the door
Note
During the printing process, residue can settle on the inspection glass and thus
cloud the glass.
Regarding the view of the working section, visibility can be impaired if the glass is
not cleaned from time to time.
1. Clean the glass on both sides using a soft cloth and a glass cleaner.
2. Wipe the glass dry.
Pos: 180 /Sintratec /+++++++ + Seitenumbruch ++++ ++++ @ 3\ mod_146398 1070991_0.docx @ 7762 @ @ 1