Sintratec S1 - Page 65

76 pages

Save Page as PDF

To Next Page

To Previous Page

Shutdown and disposal

Sintratec S1 BA_S1_en 1.1 65 / 76

As with plastic elements, powder can be handed over for recycling.

Pos: 225 /Allge mein/+++++++++ +++ Neues Kapi tel ++++++++++++ @ 0\mod_1414754 200269_0.doc x @ 6973 @ @ 1

Main Page

Table of Contents3
CE Declaration of Conformity6
About this Manual7
Use and Storage7
Contact Address of Manufacturer7
Support8
Symbols, Abbreviations and Presentation9
Scope9
Other Applicable Documents10
Warranty and Guarantee10
Safety11
General Information on Safety11
Compliance with the Operating Manual11
Intended Use12
Improper Use of the Device12
Presentation of Hazard-Related Information13
Safety and Warning Signs at the Device14
Safety Equipment15
Conversions and Unauthorised Modifications16
General Safety Information16
Personal Protective Equipment16
Information on Certain Hazards and Residual Risks17
Hazards Due to Electrical Energy17
Hazards Due to Laser Radiation17
Hazards Due to Hot Places18
Hazards Due to Moving Parts18
Hazards Due to Gases, Vapours and Dust18
Hazards to the Environment19
Conduct in Case of Emergency19
Technical Data20
Printing Performance20
Specifications for Powder20
Specifications for Computer Using "Sintratec Central" Print Software21
Nameplate22
Product Description23
Structure and Views23
Function27
Installation and Start-Up28
Safety28
Interim Storage28
Unpacking29
Checking the Delivery29
Scope of Delivery30
Place of Installation, Positioning30
Installing the "Sintratec Central" Print Software31
Electrical Connection32
Data Connection33
Initial Start-Up34
Operation35
Safety35
Personal Protective Equipment35
Operating and Auxiliary Materials35
Printing Process36
Switching on the Device36
Filling Device with Powder37
Loading of 3D Model Data for Print Object39
Setting Parameters41
Starting the Printing Process43
Removing the Print Object and Performing Finishing Work44
Cleaning the Device45
Analysis and Re-Calibration45
Treating the Residual Powder47
Cleaning and Servicing48
Safety48
Personal Protective Equipment49
Cleaning50
Cleaning Intervals50
Auxiliary Materials50
Emptying the Excess Powder Container50
Emptying of Collecting Tray51
Cleaning of Glass Cover of Laser52
Cleaning the Working Section53
Cleaning the Inspection Glass in the Door53
Cleaning the Rear Section54
Maintenance55
Maintenance Intervals55
Replacement of a Platform55
Replacing a Rear Container Wall56
Replacement of Fan Filters58
Faults and Problems59
Safety59
Personal Protective Equipment60
Action in Case of Faults and Problems60
Spare Parts61
Ordering Process61
Spare Parts List61
Shutdown and Disposal63
Safety63

Sintratec S1 - Page 65

Table of Contents