Page 50 December 2007
Rough Terrain Electric Scissors
Start Operation Section 3 - Operation
3.8-3 To Activate Platform Control Console
1. Turn main power disconnect switch to “ ”on
position.
2. On the base control console, pull out the “ ”
emergency stop button.
3. Insert key into platform/off/base key switch and
turn it to “ ” enable platform controls.
WARNING
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
4. Use the ladder of aerial platform to access
platform.
5. Close the gate.
6. On platform control console, pull out “ ”
emergency stop button.
3.8-4 To Raise or Lower Platform Using Platform
Control Console
WARNING
Be aware of overhead obstructions or
other possible hazards around the aerial
platform when lifting.
WARNING
Do not lower the platform unless the
area below is clear of personnel and
obstructions.
1. Activate platform control console (refer to
Section 3.8-3).
2. On platform control console, select lift/drive switch
to “ ” lift position.
3. Activate and hold “ ” enable trigger switch.
4. Move controller handle forward “ ” to raise or
backward “ ” to lower the platform, until desired
height is reached.
NOTE
Lowering is not proportional.
5. Return controller to neutral center position to stop.
Release enable trigger switch.
WARNING
To protect against unintended movement
of the aerial platform, push in the
emergency stop button after you have
arrived at your desired location or
elevation.
NOTE
If the tilt alarm sounds and the platform does
not, or only partially raises, immediately
lower the platform completely and ensure
that the aerial platform is on a firm, level
surface.
To Next Page
Loading...
Need help?
General
