Rough Terrain Electric Scissors
December 2007 Page 71
Table 4.6 Operator’s Daily Inspection Checklist
P
F
R
NA
N/A P F R N/A P F R
Function Tests
Motor/Hydraulic Compartment
Platform Assembly
1118AB_CE
Rollers Test Horn
Lift Cylinder(s) Test Load Sensing System
Scissor Guards Test Outriggers (If Equipped)
Maintenance Support Test Driving
Scissor Assembly Test Elevated Drive Speed
Scissor Bumpers Test Brakes
Platform Control Console Test Lowering Warning
Lifting Mechanism Test Steering
Platform Control Console
Lanyard Attachment Anchors Test Emergency Stop
AC Outlet on Platform Test Enable Trigger Switch
Manuals Test Platform Raising/Lowering
Hydraulic Return Filter Test Platform Raise/Lower Switch
Main Manifold Test Emergency Lowering
Gear Type Flow Divider Test Free-wheeling
Hydraulic Tank Test Platform/Off/Base Key Switch
Hydraulic Oil Test Emergency Stop
Battery
Hydraulic Pump Base Control Console
Test Main Power Disconnect Switch
Main Power Disconnect Switch Emergency Lowering Access Rod
Base Control Switches Ladder
Load/Tilt Sensor Outriggers (If Equipped)
Limit Switches Steer Cylinder Assembly
Hydraulic Splitter Manifold
Battery/Electrical Compartment Tie Rod
Visual and Daily Maintenance Inspections Base
Labels Base Weldment
Electrical Wheel/Tire Assembly
- FAIL
- REPAIRED
- NOT APPLICABLE
Time: Operator's Signature:
Each item shall be inspected using the appropriate section of the Skyjack operating manual.
As each item is inspected, check the appropriate box.
- PASS
OPERATOR'S DAILY INSPECTION CHECKLIST
Serial Number:
Model:
Hourmeter Reading: Operator's Name (Printed):
Date:
Note:
Make a copy of this page or visit the Skyjack web site:
www.skyjack.com for a printable copy.
To Next Page
Loading...
Need help?
General
