Page 30 December 2007
Rough Terrain Electric Scissors
Function Tests Section 2 - Familiarization
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
contained in this operating manual and on the aerial platform.
FAMILIARIZATION
Left-Rear
Right-Rear
Right-Front
Left-Front
Platform Control
Console
Outrigger
Control Console
• Test Hydraulic Outriggers (If Equipped)
(For Hydraulic Outrigger Operation, refer to
Section 3.8-9)
1. Ensure aerial platform is parked on a firm,
level surface and free from obstructions.
2. Ensure platform is fully lowered.
3. Ensure outriggers are fully retracted.
4. Auto-level (If equipped):
Use auto-level to extend outriggers.
Result: All four outriggers will extend
until they are supporting weight and bring
machine to within level.
5. Once auto-level is complete, attempt to lift
platform 1 foot and then lower the platform
to stowed position.
Result: Platform will lift and lower.
6. With platform at stowed position, fully
retract all outriggers using auto-level.
Result: All four outriggers will retract until
they are in the stowed (up) position.
WARNING
Ensure that there are no personnel
or obstructions in the path of travel,
including blind spots.
7. Drive the aerial platform to maximum
speed.
Result: Aerial platform drives at high
speed.
WARNING
Be aware of overhead obstructions or
other possible hazards around the aerial
platform when lifting or driving.
8. Lift platform to 12 feet (measured from the
bottom of the tires to the platform surface)
from stowed position.
Result: Lift function will operate.
9. Drive aerial platform at raised height (12
feet).
Result: Aerial platform drives at slow
speed.
10. Attempt to operate outriggers at raised
height (12 feet).
- Attempt to partially extend Left-Front
Outrigger (approximately 4”).
Result: Outrigger will not extend.
- Attempt to partially extend Right-Front
Outrigger (approximately 4”).
Result: Outrigger will not extend.
To Next Page
Loading...
Need help?
General
