Chapter 5 Connecting computers and other devices
docs.smarttech.com/kb/171745 67
Cable type Maximum length Recommendation
USB Type-C 6' 6" (2 m) for
SuperSpeed 5Gbps
cables
USB-IF certified USB 3.2 Gen 1 Type-C cable,
SuperSpeed (5 Gbps) support
To use a USB Type-C cable for video, you need:
l
A full-featured cable that supports SuperSpeed
5Gbps (or faster) data rates.
l
A computer that supports Display Port Alternate
Mode via USB Type-C
Note
The USB Type-C connector on the display can supply
up to 15 W of power to connected devices.
Using cables that exceed these maximum lengths may produce unexpected results, intermittent loss of
picture, or degraded picture quality and USB connectivity.
Sharing USB Type-B receptacles
The HDMI, VGA, and Display Port connectors on the side connector panel (back of the display) all share
a single USB Type-B receptacle on this panel. This means the touch system can be used with only one
device connected to these video inputs.
USB Type-B receptacle Video connectors
Touch
l
HDMI 1
l
HDMI 2
l
VGA
l
Display Port
Connecting a SMART OPS PC module
If your organization has purchased a SMART OPS PC module, you or your
organization’s installers can install the module in the display’s accessory slot
following the OPS PC module’s installation instructions
(docs.smarttech.com/kb/171775 or docs.smarttech.com/kb/171544). You can
then view the OPS PC module’s input on the display.
See
SMART OPS PC modules user guide
(docs.smarttech.com/kb/171747)
To Next Page
Loading...
Need help?
General
