SMART Board GX User Manual

Chapter 2 Installing the display
smarttech.com/kb/171744 29
1.
Press the Settings button on the front control panel.
2.
Tap the Network icon to open the Wi-Fi Guest screen.
3.
Ensure Advanced setup is selected.
4.
In the Proxy Settings list, select Manual.
5. Fill out the three proxy server fields as necessary.
6.
Select Connect to save the settings.
Set up on a secured network:
1.
Press the Settings button on the front control panel.
2.
Tap the Network icon to open the Wi-Fi screen.
3.
In the Proxy Settings list, select Manual.
4. Fill out the three proxy server fields as necessary.
5.
Select Connect to save the settings.
To install a digital network certificate for a Wi-Fi network
To improve security and ensure network authentication, you can install a Secure Sockets Layer
(SSL)certificate on the display.
1.
Press the Settings button on the front control panel.
2.
Tap the Network icon > Wi-Fi > Install certificates.
3.
Tap the menu icon and browse to the certificate (for example, a folder on the display or a
connected USB drive).
4. Tap the certificate.
The certificate installs.
5.
If Wi-Fi is off, turn the Wi-Fi Switch on.
6. Select a security enabled wireless network.
7.
Tap CA certificate > Use system certificates.
To connect to an Ethernet network
1. Connect an Ethernet cable to either of the RJ45 jacks on the display.
2.
Press the Settings button on the front control panel.

SMART Board GX Specifications

General

Aspect Ratio	16:9
Touch Points	20
Response Time	8 ms
Brightness	350 cd/m²
Display Size	75 inches
Resolution	4K UHD (3840 x 2160)
Connectivity	HDMI, USB, VGA
Display Type	LED
Viewing Angle	178°
Included Software	SMART Notebook