SMART KAPP-IQ65-V2 Installation And Maintenance Guide

CHAPTER 7
MAINTAINING THE DISPLAY
57 smarttech.com/kb/171167
To update firmware
See SMARTBoard 6000 series firmware.
Turning the display off and back on
In some situations, you need to turn off the display for a period of time. You can turn it back on
after.
To turn the display off
1.
Press the Standby button on the front control panel twice.
2. Flick the switch beside the AC power inlet to the OFF(O) position.
NOTE
Wait at least 30 seconds before turning the display back on.
To turn the display back on
Flick the switch beside the AC power inlet to the ON(I) position.
Resetting the display
You can reset the display and the iQ appliance using the front control panel.
To reset the display
1.
Press the Standby button on the front control panel.
A message appears on the screen, prompting you to either press the button again to enter
Standby mode or press and hold the button to reset the display.
2.
Press and hold the Standby button until the screen turns black.
The display and iQ appliance reset.

SMART KAPP-IQ65-V2 Specifications

General

Brand	SMART
Model	KAPP-IQ65-V2
Category	Monitor
Language	English