Smartgen ALC404 - Deep Sleep Mode; Conditions of Entering into Deep Sleep Mode; Exit Deep Sleep Mode Method

ALC404 LIGHTING TOWER CONTROLLER USER MANUAL
ALC404 Lighting Tower Controller 2018-11-06 Version 1.1 Page 68 of 83
7.19 DEEP SLEEP MODE
7.19.1 CONDITIONS OF ENTERING INTO DEEP SLEEP MODE
Conditions of entering into low power consumption mode are as follows,
Condition 1: Generator states in standby status, all lights are turned off and no buttons are pressed
before deep sleep delay expired.
Condition 2: Digital input port 1 configured as 04 Remote Start, and auto remote start signal is
deactivated.
Condition 3: There are no auto start signals in 3 minutes.
Controller enters into low power consumption mode automatically if meet conditions as follows: (1)
satisfy condition 1 in manual mode; (2) satisfy condition 1 and condition 2 simultaneously in remote start
mode; (3) satisfy condition 1, condition 2 and condition 3 simultaneously in both timer start mode and
sunrise/set start mode.
7.19.2 EXIT DEEP SLEEP MODE METHOD
Methods of exiting deep sleep mode are as follows,
Method 1: Press or button of controller to exit low power consumption mode.
Method 2: Realizing remote start to wake controller from deep sleep mode must configure input port 1
as 04 Remote Start Input, firstly, activate input port 1 and then deactivate it to exit low power consumption.
Method 3: In the mode of timer start mode or sunrise/set, system will wake controller from deep sleep
mode. Wake time is pre-set auto start time plus 3s.
Controller exit low power consumption mode by the following ways: (1) satisfy method 1 in manual
mode; (2) satisfy method 1 or method 2 in remote start mode; (3) satisfy method 1or method 2 or method 3
in both timer start mode and sunrise/set start mode.
NOTE：If awake from deep sleep mode, controller will re-read “Power on mode”, thus, recommend users to
set controller “Power on mode” before controller enters into deep sleep mode.