Introduction
1-4
1
LED Indicators
The
wireless AP/Router
includes nine status LED indicators, as described in the
following figure and table.
Figure 1-4. LED Indicators
LED Status Description
POWER On Green Indicates that the system is working normally.
WAN On/Flashing Green Indicates a valid link on the WAN Ethernet port. Flashing indicates
network activity.
Off The Ethernet port has no valid link.
LAN (4 LEDs) On/Flashing Green Indicates a valid link on the LAN Ethernet port. Flashing indicates
network activity.
Off The Ethernet port has no valid link.
WLAN On/Flashing Green Indicates the 802.11n radio is enabled. Flashing indicates wireless
network activity.
Off Indicates the 802.11n radio is disabled.
WPS On (for 10 seconds) Indicates the WPS authentication of a device has been successfully
completed.
Fast Flashing Green Indicates the WPS authentication of a client device is in progress.
Slow Flashing Green
(for 10 seconds)*
Indicates the WPS authentication of a device did not complete after 120
seconds.
Off Indicates that WPS is not in progress.
Power
WPS Link/Activity
802.11n Link/Activity
WAN Link/Activity
LAN Link/Activity
3G USB Link
To Next Page
Loading...
