Initial Configuration
4-14
4
WiFi
Enables a WAN connection to a normal remote AP over a wireless 802.11b/g/n
connection. For this WAN setting, the wireless AP/Router operates as a Wi-Fi client
to the remote AP.
Figure 4-16. Setup Wizard - WAN WiFi
• Wireless MTU: Sets the maximum packet size that the WAN port may transmit.
The Maximum Transmission Unit (MTU) is expressed in bytes. (Default:1460
bytes)
• Wireless MRU: Sets the maximum packet size that the unit may receive from other
units on the network and sends a message to inform them of the set threshold.
Maximum Receive Unit (MRU) is expressed in bytes. (Default: 14602 bytes)
Note: Only change the default MTU and MRU values if specifically instructed by the
wireless service provider.
• Wireless Network Mode: Sets the wireless network mode to Static IP or DHCP.
(Default: DHCP)
Note: For detailed AP Client Setting information, see “AP Client Settings” on page 5-35.
To Next Page
Loading...
