System Configuration
5-14
5
PPTP
Enable the Point-to-Point Tunneling Protocol (PPTP) for implementing virtual private
networks. The service is provided in many European countries.
Figure 5-29. WAN Settings for PPTP (Router mode)
PPTP — Enable the Point-to-Point Tunneling Protocol (PPTP) for implementing
virtual private networks.
• PPTP MTU: Sets the maximum packet size that the WAN port may transmit. The
Maximum Transmission Unit (MTU) is expressed in bytes. (Default:1460 bytes)
• PPTP MRU: Sets the maximum packet size that the unit may receive from other
units on the network and sends a message to inform them of the set threshold.
Maximum Receive Unit (MRU) is expressed in bytes. (Default: 1460 bytes)
Note: Only change the default MTU and MRU values if specifically instructed by the
PPTP service provider.
• PPTP Network Mode: Sets the PPTP network mode to Static IP or DHCP.
(Default: DHCP)
To Next Page
Loading...
