Wireless Settings
5-25
5
Advanced Settings
The Advanced Setting page allows you to configure the more advanced radio
settings, many of which are enabled by default.
Click “Wireless Settings” followed by “Advanced Setting.”
Figure 5-38. Advanced Radio Settings
• b/g Protection – Enables a backward
compatible protection system for
802.11b clients. There are three modes.
(Default: Auto):
- Auto: The wireless AP/Router enables
its protection mechanism for 802.11b clients when they are detected in the
network. When 802.11b clients are not detected, the protection mechanism is
disabled.
- Always On: Forces the unit to always use protection for 802.11b clients,
whether they are detected in the network or not.
- Always Off: Forces the unit to never use protection for 802.11b clients. This
prevents 802.11b clients from connecting to the network.
Note: Enabling “Always On” b/g Protection can slow throughput for 802.11g/n clients by
as much as 50%.
• HT Operation Mode – Packets from
802.11n clients are referred to as High
Throughput (HT) Greenfield packets, in other
words packets that can be transmitted at
rates of up to 300 Mbps assuming that HT
Channel Bandwidth is set to 20/40Mhz, see HT Channel Bandwidth next page.
To Next Page
Loading...
Need help?
General
