Initial Configuration
4-12
4
• PPTP Network Mode: Sets a PPTP network mode. (Default: DHCP)
• IP Address: Sets the static IP address. (Default: 0.0.0.0, available when PPTP
Network Mode is set to static IP.)
• Subnet Mask: Sets the static IP subnet mask. (Default: 255.255.255.0, available
when PPTP Network Mode is set to static IP.)
• Default Gateway: The IP address of the gateway router for the wireless AP/
Router, which is used if the requested destination address is not on the local
subnet.
• PPTP Username: Sets the PPTP user name for the WAN port.
(Default: PPTP_USERNAME; Range: 1~32 characters)
• PPTP Password: Sets a PPTP password for the WAN port. (Default:
PPTP_PASSWORD; Range: 1~32 characters)
L2TP
Enables the Layer Two Tunneling Protocol (L2TP) for implementing virtual private
networks. The service is provided in many European countries.
Figure 4-14. Setup Wizard - WAN L2TP
To Next Page
Loading...
