Initial Configuration
4-2
4
Using the Setup Wizard
There are only a few basic steps you need to set up the wireless AP/Router and
provide a connection for network access for other wireless stations.
The Setup Wizard takes you through configuration procedures for the general
network settings. Follow these steps:
1. Launch the Setup Wizard – Click “Setup Wizard” on the left side of the screen
to enter the setup wizard page. Click Next to begin the setup.
Figure 4-2. Setup Wizard
2. Date/Time Configuration – Select a time zone according to where the device
is operated. Click Next after completing the setup.
Figure 4-3. Setup Wizard - Date/Time
To Next Page
Loading...
