Using the Setup Wizard
4-3
4
3. WAN Configuration – Specifies the Internet connection parameters for the
wireless AP/Router’s WAN port. Click Next after completing the setup. The
interface provides the facility for Dual WAN connections for purposes of
backing up the main internet connection.
Figure 4-4. Setup Wizard - WAN Configuration
The displayed items on this page are described in the sections that follow:
WAN Connection — By default, the access point WAN port is configured with
DHCP enabled. After you have network access to the access point, you can use the
web browser interface to modify the initial IP configuration, if needed. The options
are Static IP, DHCP, PPPoE, 3G, PPTP, L2TP, Bigpond and WiFi. Each option
changes the parameters displayed below it. (Default: DHCP)
Backup WAN — A backup failsafe connection for the WAN port (Dual WAN.)
Options are determined by the WAN Connection selected. Backup WAN and WAN
Connection parameters are identical for each of their eight equivilent modes: Static
IP, DHCP, PPPoE, 3G, PPTP, L2TP, Bigpond and WiFi. (Default: None)
• WAN detect IP address: IP address used to detect if the primary WAN connection
is on or off.
• Backup WAN detect IP address: IP address used to detect if the backup WAN
connection is on or off.
• ICMP detect timeout: Set the ICMP (Ping) time out.
• Main WAN Fallback: When the Backup WAN is enabled, Main WAN Fallback can
be enabled to periodically search the primary WAN port for recovery of the lost
connection. If connection is re-established the connection switches back to the
primary WAN connection. (Default: Disabled)
Note: When 3G is selected as the primary WAN Connection the Backup WAN must be a
DSL/Cable connection.
To Next Page
Loading...
Need help?
General
