System Configuration
5-8
5
Static IP
Configures the unit to use the same IP address each time it connects.
Figure 5-25. WAN Settings for Static IP (Router mode)
Static IP — Configures a static IP for the WAN port.
• Static IP MTU: Sets the maximum packet size that the WAN port may transmit.
The Maximum Transmission Unit (MTU) is expressed in bytes. (Default:1500
bytes)
• Static IP MRU: Sets the maximum packet size that the unit may receive from other
units on the network and sends a message to inform them of the set threshold.
Maximum Receive Unit (MRU) is expressed in bytes. (Default: 1500 bytes)
• IP Address: Sets the static IP address as given by the PPTP service provider.
(Default: 0.0.0.0, available when PPTP Network Mode is set to static IP.)
• Subnet Mask: Sets the static IP subnet mask. (Default: 255.255.255.0, available
when PPTP Network Mode is set to static IP.)
• Default Gateway: The IP address of the gateway router for the wireless AP/
Router, which is used if the requested destination address is not on the local
subnet.
To Next Page
Loading...
