9
Introduction Power Sources
2.3.4 S (Shortcut) Key
Use the Shortcut key to quickly perform routine tasks, such as capturing an image of the current
screen, with a single press. The Shortcut, or S, key can be programmed to perform a number of
different functions. Refer to Configure Shortcut Key‚ on page 123 for additional information.
2.3.5 Power Key
The Power key powers up the tool, and turns it off.
2.4 Power Sources
Your Display Device can receive power from any of the following sources:
• Internal Battery
• AC Power Supply
• Vehicle Power
2.4.1 Internal Battery
The tool can be powered from the internal rechargeable battery. A fully charged standard battery
provides sufficient power for about 3 hours of continuous operation.
An LED on top of the unit (Figure 2-2) illuminates to indicate DC power is being supplied to the
tool. The internal battery is recharged whenever an outside power source is provided. Either
connecting the Data Cable to a powered data link connector (DLC) on a vehicle, or connecting the
AC Power Supply to a power outlet charges the internal battery.
2.4.2 AC Power Supply
The diagnostic tool can be powered from a standard wall socket using the AC power supply and
power adapter. The jack on the output cable of the AC power supply attaches to the DC power
supply input port on top of the diagnostic tool. Use only the AC power supply provided.
To Next Page
Loading...
Need help?
General
