56
Operations Utilities
Scanner Units
The Scanner Units selection is used to change the units of measurement. Choose between US
Customary or metric units of measure for available data parameters.
All measurement units return to their default values when the internal batteries are disconnected
or different software is selected.
z To change a setting:
1. Select Utilities > Tool Setup > Scanner Units.
The Scanner Units dialog box displays (Figure 5-59).
Figure 5-59
Sample Scanner Units dialog box
2. Select from the drop-down lists as necessary.
The drop-down list closes automatically once a selection is made.
3. Press N/X to close the Scanner Units dialog box.
Save Data
Selecting Save Data lets you adjust the amount of data recorded after a trigger-point. Save Data
also lets you set the saving and loading location for all saved files, and whether to save image files
in bitmap or jpeg format.
See “Setting a Destination for Saved Data” on page 50. Use the procedure below to adjust saving
preferences.
z To adjust saving preferences:
1. From the main menu, select Utilities > Tool Setup > Save Data.
The Save Data dialog box displays (Figure 5-60).
Table 5-2
Units of measurement—defaults and options
Setting Default Option
Temperature degrees Celsius (°C) degrees Fahrenheit (°F)
Air Pressure (including
manifold pressure)
kilopascals (kPa) inches of mercury (“Hg)
Speed kilometers per hour (kph) miles per hour (mph)
Other Pressures kilopascals (kPa) pounds per square inch (psi)
To Next Page
Loading...
Need help?
General
