User Manual |
30
3D Printing - 03 How to 3D Print
(3) Calibrate the rst point. Place the Calibration Card or a piece of paper between the nozzle and Print Sheet.
(4) Fine-tune the rst point. Select the offset per travel (0.05 mm, 0.1 mm, or 0.5 mm). Keep adjusting the height
of the nozzle tapping Up and Down, until you feel slight resistance when you pull out the Calibration Card and it
should be wrinkled when you push it forward. Tap Next to calibrate the next point.
To Next Page
Loading...
