Snell Sirius 830 - Nucleus2 2463 & Nucleus 2450 Router Control Module Snapshot

To Next Page

To Previous Page

Sirius 800 www.snellgroup.com Nucleus Upgrade (RollCall) and Maintenance

9.3 Nucleus2 2463 & Nucleus 2450 Router Control Module Snapshot

Router Snapshot uses the RollMechanic Backup and Restore functions to backup the current

router video crosspoints (video routes) and AHP module audio processing settings. The

snapshot can then be restored to the router at a later date to reproduce the video routes and

audio processing settings (audio settings 2463 only) from the point in time the snapshot was

taken.

See the RollMechanic Operator’s Manual for details on how to take router snapshots and how

to restore snapshots (backup and restore).

Important:

Router Snapshot Pre-requisites:

• RollMechanic installed and working on the same network as the router controllers

(see the RollMechanic Operator’s Manual for details).

• RollCall must be enabled on the Nucleus controller(s).

RollCall is enabled by default, to check:

• Nucleus2 2463, see section 9.5.7

• Nucleus 2450, see section 9.6.3

• The Nucleus controller must have the RollCall Command Set and Webcontent files

from Workbench version 3.14.2 or later installed.

• Nucleus2 2463, see section 10.2.4

• Nucleus 2450, see section 10.5

Router Snapshot Notes:

• Nucleus 2463 snapshots are not compatible with Nucleus 2450 controllers and vice

versa.

• Audio crosspoints are not backed up.

• If the input/output module types or positions are changed after a snapshot has

been taken a subsequent restore will only be made for those modules that have not

changed their slot position in the router.