12
v1.02
Admin and Installation Guide M900 Important Information
Health and safety information FCC
Exposure to radio frequency (RF) signals
This device is a radio transmitter and receiver. It is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are based on the safety
standards previously set by both U.S. and international standards bodies:
This product has been shown to be capable of compliance for localized specific absorption rate (SAR)
for uncontrolled environment/general population exposure limits specified in ANSI/IEEE Std. C95.1-
1992 and has been tested in accordance with the measurement procedures specified in FCC/OET
Bulletin 65 Supplement C (2001) and IEEE Std. 1528-2003 (December 2003).
Standards conformance
This device is FCC certified and meets US health, safety, and environmental standards. The
declaration of conformity can be downloaded at www.snom.com/conformity.
FCC ID: T7HX8663
Unauthorized opening, changing, or modifying the device will cause the warranty to lapse and may
also result in the loss of the FCC certification. In case of malfunction contact authorized service
personnel, your seller, or Snom.
• Safety: IEC 60950-1:2005
• Connectors
◦ PoE: RJ45 (8P8C)
◦ Power jack: DC 5VDC@2A (power adapter not included in delivery)
• Power.
◦ Power over Ethernet (PoE): IEEE 802.3, Class 2, 10/100 Base-T interface. If If PoE is not
available, the power adapter can be ordered separately:
◦ Power adapter: (not included in delivery): Ten Pao SMPS power adapter, 5VDC 2A, model no.
S018BAM0500200, Snom article no. 00004440 (US)
To Next Page
Loading...
