71
v1.02
Admin and Installation Guide M900 Description of Settings
Repeaters
For information on registering repeaters, see "Registering M5 repeaters" on page 26.
Setting Description
Idx Index of repeaters. Repeaters are numbered consecutively by the base
station. With checkbox for registering them at and deregistering or deleting
them from the base station.
RPN • Assigned by base station during automatic registration.
• Selected from drop-down menu during manual registration of daisy-
chained repeaters.
Name/IPEI The name given to the repeater during the registration process and its IPEI or
only its IPEI, if no name assigned.
DECT sync source Assigned by base station during automatic registration. Selected from drop-
down menu during manual registration of daisy-chained repeaters.
DECT sync mode The sync mode selected for the repeater during the registration process.
Options:
Local aut omatical: Recommended when registering repeaters directly at the
base station or - in a multicell system - directly at the primary or any
secondary base station in the chain.
Manual: Obligatory when daisy-chaining repeaters to other repeaters.
State Enabled: Repeater has been registered on the base station.
Present@RPNxx: Repeater with DEC source RPNxx (base station or other
repeater) is connected to the base station.
FW info The firmware version on the repeater
FWU progress Progress states:
O: No update in progress.
Initializing: Update has been initiated.
X%: Update in progress, X% completed.
VerifyingX%: FWU writing is done, verification X% completed.
"Conn. term. w ait” (Repeater): Firmware has been updated; repeater will
restart when there are no active calls in system.
Complete HS/repeater: Update complete.
Error: Unable to update (file not found, file not valid, etc.)
To Next Page
Loading...
