72
v1.02
Admin and Installation Guide M900 Description of Settings
Alarm
For information on configuring alarm settings and selecting them for individual handsets, see
"Emergency alarm" on page 30. The M25 does not support emergency alarms.
This menu contains the available emergency alarm profiles that can be set for handsets registered at
the base station. Configured profiles are selected for individual handsets on the Handset page. For
more information, see "Selecting emergency alarm setting" on page 25 .
Setting Description
Idx Alarm profiles are numbered consecutively by the base station.
Profile alias Optional: You can assign a name to each configured profile. The name is
added in parentheses to the available profiles on the handset page.
Alarm type Select Alarm Button from the drop-down menu to enable the alarm feature.
Default: Disabled.
Alarm signal The Call setting is mandatory. When the alarm button on the handset is
pressed, the handset will call the phone number specified in the handset's
Alarm settings.
Mandatory default: Call.
Note: Changes to the following settings do not aect the M65 which always uses their default settings.
Stop alarm from handset Establishes whether or not an alarm can be cancelled from the handset.
Default: Enabled.
Trigger delay The number of seconds from the moment the handset's alarm button is
pressed until the handset calls the alarm number or, if a pre-alarm delay is
also configured, before the pre-alarm delay is triggered.
Default: 0.
Stop pre-alarm from handset Establishes whether or not a pre-alarm can be cancelled from the handset.
Default:: Enabled.
Pre-alarm delay The number of seconds from the moment the handset's alarm button is
pressed until the handset calls the alarm number. The display will show
the "Pre-alarm triggered" message, and the emergency ringer, if set, will be
played.
Default: 0.
Howling Establishes whether or not the handset will emit a howl while it is dialing the
emergency number. (Howling not available on M65)
Default: Enabled.