Snom M900 - Emergency Alarm

To Next Page

To Previous Page

v1.02

Admin and Installation Guide M900 Conﬁguring

Emergency alarm

Seven emergency alarm proﬁles can be conﬁgured on this page. All conﬁgured emergency alarm

settings can be selected individually for any handset registered at the base station if that handset has

an emergency alarm function. After an emergency alarm proﬁle has been conﬁgured in this menu, it

can be selected for individual handsets on the handset page.

Note: All features of the emergency alarm settings are available on the M70, M80, M85, and M90.

The M65 can be enabled to send an alarm call to the speciﬁed alarm number using the factory

settings; the M25 does not have an emergency alarm.

• Proﬁle alias. Optional name for alarm proﬁle; will be added to proﬁle number in parentheses.

• Alarm type. Select Alarm Button from the drop-down menu to enable the alarm feature. Default

setting: Disabled.

• Alarm signal. The Call setting is mandatory. When the alarm button on the handset is pressed,

the handset will call the phone number speciﬁed in the handset's Alarm settings (see "Selecting

emergency alarm setting" on page 25).

The following settings apply to the M70, M80, M85, and M90. The M65 uses the default settings

regardless of the setting, except for Howling which is not available on the M65.

• Stop Alarm from Handset. This setting establishes whether or not an alarm can be cancelled

from the handset. Default setting: Enabled.

• Trigger Delay. Enter the number of seconds from the moment the handset's alarm button is

pressed that the handset will wait before calling the alarm number or, if a pre-alarm delay has

also been conﬁgured, before the pre-alarm delay is triggered. Default setting: 0.

• Stop Pre-Alarm from Handset. This setting establishes whether or not a pre-alarm can be

cancelled from the handset. Default setting: Enabled.

• Pre-Alarm Delay. Enter the number of seconds from the moment the handset's alarm button is

pressed that the handset will wait before calling the alarm number. The display will show the

"Pre-alarm triggered" message, and the emergency ringer, if set, will be played. Default

setting: 0.

• Howling (not available on M65). This setting establishes whether or not the handset will emit a

howl while it is dialing the emergency number. Default setting: Disabled.

Other manuals for Snom M900