59
v1.02
Admin and Installation Guide M900 Description of Settings
Setting Description
Notes Applicable to some locations in US and Brazil.
When counties, towns etc. are using dierent time settings than the timezone
they are located in, a text field will open with description of the exception
when you select the timezone. The text field is not visible when locations
without these exceptions are selected.
Select language The language used on the web interface of the base station can be set
independently from the country setting. Select a language from the drop-
down menu.
Default: English
Set timezone by country/
region
When checked, the timezone of the selected country/region will be used.
When unchecked, the time zone (UTC +/- n) and daylight saving time settings
can be selected manually from the drop-down menus of the individual
settings.
Default: Checked.
Set DST by country/region When checked, the DST of the selected country/region will be used. When
unchecked, the daylight saving time settings can be selected manually from
the drop-down menus of the individual settings.
Default: Checked.
Time server
The time server is mandatory for multicell configurations where it supplies the time used for data
synchronisation. The time server is also used in the debug logs, for SIP trace information pages, and
to determine when to check for new configuration and firmware files.
Note: Multicell systems will not work without a configured time server.
When time server parameters are changed, the system must be rebooted. Click on the Save and
Reboot button. It can take up to 15 minutes before all base stations are synchronized, depending
on the number of base stations in the system.
For stand-alone base stations, setting the time server is optional.
Setting Description
Time server IP address or DNS name of NTP server
Valid inputs: URL or IP address (IPv4 only).
Default: empty.
Allow broadcast NTP Check to use time server.
Default: Checked
Refresh time (h) Time interval in hours within which the time server refreshes.
Valid inputs: Positive integers
To Next Page
Loading...
