41
v1.02
Admin and Installation Guide M900 Description of Settings
• Operation time: Counter - time elapsed since last reboot of base
• RFPI address: RFPI: The Radio Fixed Part Identity is a unique identifier frequently transmitted by
the base station.
• MAC address: The media access control (MAC) address is a unique identifier assigned by the
manufacturer.
• IP address: The Internet Protocol address assigned by the network the base station is located in.
• Reboot: Date, time, and cause of the last six reboots (e.g., normal reboot, power loss)
• Firmware version: Contains the version, e.g. 04.50, and the branch, e.g. B0005.
• Firmware URL: The address of the server from which firmware updates are downloaded.
• Base station status: In use or Idle
• SIP identity status on this base station. This is the status of the handsets registered and currently
present at this base station. Note: Handsets that are currently turned o are not shown; you can
still view them on the Extensions page, showing their state as "detached". Error messages may
dier, depending on the setup of your PBX.
• Reboot button (Fig. 1): Clicking this button will initiate a reboot as soon as the base station is
idle, i.e., when there are no current calls, handsets accessing the directory, or ongoing firmware
updates.
• Forced reboot button (Fig. 1): Clicking this button will initiate an immediate reboot; active calls,
firmware updates, and directory access from all handsets will be terminated immediately.
To Next Page
Loading...
