53
v1.02
Admin and Installation Guide M900 Description of Settings
Setting Description
SIP ToS/Qos Priority of call control signaling trac based on both IP layers of Type of
Service (ToS) byte. ToS is referred to as Quality of Service (QoS) in packet-
based networks.
Permitted values: Positive integer, default is 0x68.
RTP port The first RTP port to use for RTP streaming.
Permitted values: Port number default 50004 (depending on the setup).
RTP port range The number of ports that can be used for RTP audio streaming.
Permitted values: Positive integer, default is 40.
RTP TOS/QoS Priority of RTP trac based on the IP layer ToS byte. ToS is referred to as
Quality of Service (QoS) in packet-based networks. See RFC 1349 for details.
The "cost" bit is not supported.
• Bit 7..5 defines precedence
• Bit 4..2 defines Type of Service (ToS
• Bit 1..0 are ignored
Permitted values: Port number default 5060.
SIP registration mode
To Next Page
Loading...
