Sony LY51 - Page 63

160
English
• To enter the settings
5. Select the required signal and press
ENTER
.
Enters the output signal.
(In this case, 1st axis A/B phase output (Ab.F) is
selected.)
The setting contents light steadily for approximately
2 seconds for confirmation.
• To interrupt the settings
5. Select “End” and press
ENTER
or press
RESET
.
Interrupts the A/B phase output settings.
(Previous setting contents remain.)
(Lights)
↓
(After approx. 2 sec.)
Main display
Sub-display
Main display
Sub-display
Main display
Sub-display