106
English
Read all instructions carefully before starting use.
Save this MANUAL for future reference.
1-1. General Precautions
When using Sony Precision Technology products, observe
the following general precautions along with those given
specially in this manual to ensure proper use of the products.
•
Before and during operations, be sure to check that our
products function properly.
•
Provide adequate safety measures to prevent damages in
case our products should develop malfunctions.
•
Use outside indicated specifications or purposes and
modification of our products will void any warranty of the
functions and performance as specified of our products.
•
When using our products in combination with other
equipment, the functions and performances as noted in
this manual may not be attained, depending on operating
and environmental conditions.
1. NOTES TO USERS
1-2. Handling Instructions
•
Do not route the connecting cable and power cord together
with the machine power line in one duct.
•
Do not take the power supply from the
machine power line.
•
Connect the ground terminal of the unit to
the ground with the supplied ground wire.
•
When the power supply voltage is lower than specified,
the display may not be illuminated even with the POWER
switch turned on. Be sure to use the power in the specified
range.
•
Once the POWER switch is turned off, leave it for at least
3 seconds before turning it on again. Otherwise malfunction
may be caused.
•
Note that if the power is interrupted momentarily or the
voltage drops temporarily below the normal operating
range, an alarm may work or malfunction may occur.
Earth
Ground
wire
SIGNAL IN 1
100 - 230V
50 / 60Hz
30VA
I/O 1
EXT.I/O
I/O 2
I/O 3
LY51
Serial No.
Sony Presicion Technology inc.
MADE IN JAPAN
SIGNAL IN 2
To Next Page
Loading...
