Sony LY51 - Canceling the Zero Point Reference Mode

175
English
7-2-7. Canceling the zero point reference mode
This cancels the zero point reference mode. This operation is valid only during the zero point reference mode.
(Continued from 7-2-1.) (P.171)
1. Select “rCL” and press
ENTER
.
The REF LED goes off.
The zero point reference mode is canceled.
Note This operation differs from temporarily stopping the zero point reference mode in that operation cannot recover to the
zero point reference mode. To restart the zero point reference mode, perform the procedure again from zero point
reference load.
Main display
Sub-display