Sony LY51 - Zero Point Load; Zero Point Hold

172
English
7-2-2. Zero point load
This starts the counting from the point when the zero point is passed. The maximum, minimum and peak-to-peak values are set
to “0” and the operation restarts from the beginning.
When zero point load is performed during the zero point reference mode, the zero point reference mode is canceled.
(Continued from 7-2-1.) (P.171)
1. Select “LOAd” and press
ENTER
.
The unit is placed in the zero point load wait status.
The REF LED flashes.
You can interrupt the operation by moving the cursor to
“End” and pressing
ENTER
.
2. (Zero point passed)
The REF LED goes off and counting starts.
7-2-3. Zero point hold
This holds the display at the point when the zero point is passed. Internal counting continues.
When the zero point is held during the zero point reference mode, operation continues in this mode.
(Continued from 7-2-1.) (P.171)
1. Select “HOLd” and press
ENTER
.
The unit is placed in the zero point hold wait status.
The REF LED flashes.
You can interrupt the operation by moving the cursor to
“End” and pressing
ENTER
.
2. (Zero point passed)
The REF LED goes off and the display is held. (During the
zero point reference mode, the REF LED remains lighted.)
Holding is canceled by moving the cursor to “End” and
pressing
ENTER
.
Main display
Sub-display
Main display
Sub-display
Main display
Sub-display
Main display
Sub-display