Sony LY51 - Zero Point Reference Load; Temporarily Stopping;Recovering the Zero Point Reference Mode

174
English
7-2-5. Zero point reference load
This starts the counting from the point when the zero point is passed. The maximum, minimum and peak-to-peak values are set
to “0” and the operation restarts from the beginning.
The zero point reference mode starts after the zero point is passed.
(Continued from 7-2-1.) (P.171)
1. Select “rLd” and press
ENTER
.
The unit is placed in the zero point load wait status.
The REF LED flashes.
You can interrupt the operation by moving the cursor to
“End” and pressing
ENTER
.
2. (Zero point passed)
The REF LED lights, the zero point reference mode starts,
and counting starts.
7-2-6. Temporarily stopping/recovering the zero point reference mode
This temporarily stops the zero point reference mode. This operation is valid only during the zero point reference mode.
When executed while the zero point reference mode is temporarily stopped, operation recovers to the zero point reference
mode.
(Continued from 7-2-1.) (P.171)
1. Select “rOF” and press
ENTER
.
The REF LED goes off.
The zero point reference mode is temporarily stopped.
2. Select “rOF” and press
ENTER
.
The REF LED lights and operation recovers to the zero
point reference mode.
Main display
Sub-display
Main display
Sub-display
Main display
Sub-display
Main display
Sub-display