179
English
7-3-3. Restarting operation
(Continued from 7-3-1.) (P.177)
1. Select “rST” and press
ENTER
.
The peak value is cleared and is recalculated from the
current value at that point.
7-3-4. Absolute value display
(Continued from 7-3-1.) (P.177)
1. Select “ABS” and press
ENTER
.
The absolute value of the current value appears on the
main display for approximately 2 seconds.
If a resetting or presetting operation is not executed after
passing the zero point, the zero point value will be the same
as the current value (absolute value indication).
Note This value is displayed only and is not output.
Maximum value, Minimum
value → Current value
Peak-to-peak value → 0
Main display
Sub-display
(Absolute value)
Main display
Sub-display
To Next Page
Loading...
