2-14. Front Lens
2-14-1. Front Lens Assembly
Preparation
1. Remove the battery lid. (Refer to “2-2. Lithium Battery”.)
2. Remove the bottom cover. (Refer to “2-3. Bottom Cover and Tripod Washer”.)
3. Remove the inside panel assembly. (Refer to “2-4-1. Inside Panel Assembly”.)
4. Remove the outside panel assembly. (Refer to “2-5-1. Outside Panel Assembly”.)
5. Remove the top panel assembly. (Refer to “2-6. Top Panel Assembly”.)
6. Remove the SxS slot assembly. (Refer to “2-7-1. SxS Slot Assembly”.)
7. Remove the front panel assembly. (Refer to“2-8-1. Front Panel Assembly”.)
8. Remove the rear panel assembly. (Refer to “2-9. Rear Panel Assembly”.)
9. Remove the IO-255 assembly. (Refer to “2-11. IO-255 Board”.)
10. Remove the main heat spreader DCP. (Refer to “2-12. DCP-56 Board”.)
11. Remove the handle assembly. (Refer to“2-13-1. Handle Assembly”.)
Procedure
1. Disconnect the harness from the connector CN007 on the DCP-56 board.
2. Disconnect the three fine-wire coaxial cables from the three connectors CN101, CN003 and CN005 on the DCP-56
board.
3. Disconnect the harness from the connector CN102 on the AU-342 board.
4. Remove the four precision screws (M2.6 x 5) to detach the front bracket and the front lens assembly.
Harness
Front bracket
CN102
CN007
CN005
CN001
CN003
Harness
DCP-56 board
DCP-56 board
Fine-wire coaxial cable (R)
Fine-wire coaxial
cable (G)
Fine-wire coaxial cable (B)
AU-342 board
Precision screws
(M2.6 x 5)
Precision screws (M2.6 x 5)
Front lens assembly
5. Install the removed parts by reversing steps of removal.
2-14-2. HN-399 Board
Preparation
1. Remove the battery lid. (Refer to “2-2. Lithium Battery”.)
PMW-200/PMW-EX280
2-38
To Next Page
Loading...
