Sony SLV-286EE - Supplied Accessories; Safety Check-Out

Weight
SLV-286EE/X311:
Approx. 4.7 kg
SLV-436EE/X711}:
Approx. 5.1 kg
Supplied accessories
Remote commander RMT-V132J
(SLV-286EE/X311PS/SG)
Remote commander RMT-V141K
(SLV-436EE/X711ME/PS/SG)
Remote commander RMT-V 148M
(SLV-X711 AS/NZ)
R6 (size AA) batteries (2)
Aerial cable (1)
Mains lead (1)
Plug adaptor (1)
(E, ME Model)
Design and specifications are subject
to change without notice.
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer:
Check the area of your repair for unsoidered or
poorly-soldered connections. Check the entire
board surface for solder splashes and bridges.
Check the interboard wiring to ensure that no
wires are “pinched” or contact high-wattage
resistors.
Look for unauthorized replacement parts, par-
ticularly transistors, that were installed during a
previous repair. Point them out to the customer
and recommend their replacement.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK A OR DOTTED
LINE WITH MARK A ON THE SCHEMATIC DIAGRAMS
IN THE PARTS LIST ARE CRITICAL TO SAFE
REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
AND
OPERATION.
LISHED BY SONY.
4.
Look for parts which, though functioning, show
obvious signs of deterioration. Point them out
to the customer and recommend their replace-
ment.
Check the B+ voltage to see it is at the valies
specified.