Sony XVS-G1

141
To finely adjust the setting values of parameters
Press the [FINE] button,
turning it on.
The adjustment mode switches to
fine mode, enabling
fine adjustment of setting values using the trackball/
Z-ring.
To restrict the parameter
s targeted by the
operation
Press the [X] button, [Y] button, or [Z] button,
tu
rning it on.
This enables operation only
for the selected axis
using the trackball/Z-ring.
Setting a Crop
When a video signal and key signal are selected for
resizer mosaic/defocus, crop is disabled.
Setting a crop (menu)
1 Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Resizer Adjust/DME Select menu (11101.41).
2 Set the [Resizer] button to the on state.
3 Set the [Crop] button to the on state and set the
following parameters.
a) The entered numeric value is automatically a positive value for the
right and top edges and a negative value for the left and bottom
edges.
To soften the edges
Set the [Edge Soft] button to the on st
ate and set the
following parameter.
Setting a crop (device control block)
When the crop setting is enabled in the menu, you can
adjust the crop of the top, bottom, left, and right edges
using the device control block.
The buttons used for configuring a
crop must be assigned
to the device control block beforehand.
For details about assign
ing buttons, see “Assigning
Control Panel Buttons” (page 397).
1 Press the [M/E 1] button.
2 Press the [K1RSZ] button.
3 Press the [RSZR ON] button, turning it on.
4 Press and hold the [SHIFT] button, and press the
[BDR/CROP] button, turning it on green.
5 Select the target edge to crop using the [X] button/[Y]
button/[Z] button/[CTR] button and adjust the crop
using the Z-ring.
[X] button: Adj
ustment of crop of top edge
[Y] button: Adj
ustment of crop of left edge
[Z] button:
Adjustment of crop of right edge
[CTR] button: Adj
ustment of crop of bottom edge
If an edge to crop is not sel
ected, operating the Z-ring
adjusts the crop width of all edges.
To finely adjust the setti
ng values of parameters
Press the [FINE] button, turning it on.
The adjustment mode switches t
o fine mode, enabling
fine adjustment of setting values using the Z-ring.
Setting a CG Border
The resizers of two keys are used for CG border settings.
The combination of key pairs used is fixed (keys 1 and 2,
k
eys 3 and 4, keys 5 and 6, keys 7 and 8). The CG border
settings are configured for odd-numbered keys (1, 3, 5, 7).
This section describes setting a CG border using key 1
and key
2 as an example.
• To change the position and siz
e of the image embedded
in the border, clean mode must be enabled on the target
key. Enabling the CG border settings on key 1
automatically enables clean mode on both key 1 and
key 2.
Note
No. Parameter Adjustment
1-1 H Simultaneous adjustment of
crop
of left and right edges
a)
1-2 V Simultaneous adjustment of
crop of top and bottom edges
a)
1-3 All Simultaneous adjustment of
crop of top, bottom, left, and
right edges
a)
2-1 Top Crop of top edge
2-2 Left Crop of left edge
2-3 Right Crop of right edge
2-4 Bottom Crop of bottom edge
No. Parameter Adjustment
1 Soft Edge softness
Note
Notes