155
Rotating a wipe pattern (Rotation)
Angle
Wipes with a pattern at a fixed angle.
Speed
Rotates a pattern at a fixed speed.
Magnitude
Rotates a pattern through the speci
fied angle in a single
transition.
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Main Modify menu (11109.35).
2
In the [Rotation] group, select a rotation type.
When the [Angle] button is sel
ected, set the following
parameter.
When the [Speed] button is sel
ected, set the following
parameter.
When the [Magnitude] button
is selected, set the
following parameters.
Setting the aspect ratio of a wipe pattern
(Aspect)
You can change the aspect ratio of a pattern.
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Main Modify menu (11109.35).
No. Parameter Adjustment
1 Angle Inclination angle of pattern
• A value of –100.00
corresponds to a rotation of
one turn counterclockwise.
• A value of +100.00
correspo
nds to a rotation of
one turn clockwise.
• A value of 0.00
correspo
nds to no rotation.
Angle disabled Angle enabled
No. Parameter Adjustment
1 Speed Rotation speed of pattern
• A value of –100.00
corresponds to 1 revolution/
second counterclockwise
rotation.
• A value of +100.00
correspon
ds to 1 revolution/
second clockwise rotation.
• A value of 0.00
correspon
ds to no rotation
(stationary).
No. Parameter Adjustment
1 Angle Angle of pattern at start of
transition
• A value of –100.00
correspon
ds to a rotation of
one turn counterclockwise.
• A value of +100.00
correspon
ds to a rotation of
one turn clockwise.
• A value of 0.00
correspon
ds to no rotation.
2 Magnitude Angle of rotation through
course
of transition
• A value of –200.00
corresponds to a rotation of
two turns counterclockwise.
• A value of +200.00
correspon
ds to a rotation of
two turns clockwise.
• A value of 0.00
correspon
ds to no rotation.
Aspect disabled Aspect enabled