Sony XVS-G1

220
To record
You can record to a VTR or a disk recorder (video disk
comm
unications protocol).
Press and hold the [REC] button and press the [PLAY]
butt
on to start recording.
During recording, th
e [REC] button is lit red.
To stop recording, press the [STOP] button or the [ALL
STO
P] button.
• Recording is not possible when using the Odetics
pr
otocol or AMP protocol.
• The following limitations apply for a disk recorder
(v
ideo disk communications protocol).
– Set the disk recorder type to [Recorder].
– The maximum length of time that can be recorded in
o
ne operation is 30 minutes.
– Create a new file for recording.
– When resuming after interrupting recording,
rec
ording to a file continues from the interruption
point. To record to a file other than the selected file,
unload the file and create a new file.
Device control block display
In the device control block of the ICP-X7000, the display
sh
ows the following information.
• FILE: Recalled file name (
for disk recorder)
• CRNT: Current timecode (hour:minute:second:frame)
• START: Start point timecode
(hour:minute:second:frame)
• STOP: Stop point timecode
(hour:minute:second:frame)
The file name is displayed left-justified in ASCII
charact
ers only (up to 20 characters).
VTR/Disk Recorder Status Display
Open the following menus.
• Home > External Device > Device > Cueup & Play
men
u (16101.31)
• Home > External Device > Device > Timeline > Action
men
u (16101.41)
• Home > External Device > Device > Timeline >
R
ewind Action menu (16101.42)
Information for the assigned VT
R/disk recorder is
displayed for each channel selection button.
You can check the current timecode in [Current TC].
You can check the current VTR/disk recorder sta
tus in
[Status].
a) Not supported for the Odetics protocol and AMP protocol.
Notes
Note
Reverse
direction
Forward
direction
Low speed
Still image
Low speed
Maximum
speed
Maximum
speed
Status VTR Disk recorder
XXXX Communication with
d
evice is normal, but
status information
cannot be acquired.
Cannot communicate
with device, or
communicating but
cannot read the
device type.
Local The REMOTE/LOCAL
switch
of the device is
set to LOCAL.
Port is not open.
Tape Out No tape is loaded. No file loaded.
a)
Rec Recording Recording
a)
Cue> Cueing up in the
normal direction
–
Cue< Cueing up in the
rev
erse direction
–
Eject Ejecting cassette –
Stb Off Stopped in standby off
mode
–
Stop Stopped in standby on
mode
Stopped
Play Playing Playing
FF Fast forwarding –
Rewind Rewinding –
Shtl> Playing in the normal
di
rection in shuttle
mode
–
Shtl< Playing in the reverse
di
rection in shuttle
mode
–
Var> Playing in the normal
d
irection in variable
mode
Playing in the normal
direction in variable
mode
Var< Playing in the reverse
d
irection in variable
mode
Playing in the reverse
direction in variable
mode
Jog> Playing in the normal
d
irection in jog mode
Playing in the normal
direction in jog mode
Jog< Playing in the reverse
direction in jog mode
Playing in the reverse
direction in jog mode
Still Playing still image –