Sony XVS-G1

221
Cueup & Play
You can save cueup & play settings, such as start point/
stop point timecodes, in an effect timeline register and
then recall the settings as required.
Cueup & play is configured using the device control
bl
ock or the menu. You can recall a register in which
cueup & play settings are saved, and then control
operation using the utility/shotbox control block, utility
control block, or the menu.
Loop/recue
Loop/recue can be set for disk recorders that use the video
di
sk communications protocol.
Loop: Playback from the start poi
nt to the stop point, then
return to the start point and repeat playback.
Recue: Playback from the start poi
nt to the stop point,
then return to the start point and stop.
• Loop/recue are only available for disk recorders that
use the v
ideo disk communications protocol. Note that
these may not operate, depending on the connected
device.
• To use the loop or recue func
tion, it is necessary to
enable the function.
For details, see “Setting loop/recue” (page 425).
Notes on cueup & play
• Cueup & play cannot be configured for registers in
which a
DDR/VTR timeline is configured.
• When using a disk recorder with cueup & play, if you
car
ry out the following sequence of operations,
playback may freeze on the frame of the start point.
– Press the [RUN] button to play to a point close to the
en
d of a file t stop playback t press the [RUN]
button again.
Perform the following operatio
n if playback freezes.
– Recall another register t recall the target register
t
press the [REWIND] button t press the [RUN]
button.
Setting cueup & play (device control
block)
Set the start point, stop point, and loop/recue using the
device control block in device/frame memory/clip player
operation mode.
Selecting a region and recalling/
saving an effect timeline
register are controlled using the numeric keypad control
block or the menu.
The start delay time cannot be set using the device control
bl
ock.
1 Select an external device region and recall an effect
timeline register.
For details about recall operations using the numeric
key
pad control block, see “Recalling an Effect
Timeline” (page 258).
For details about recall operat
ions using the menu,
see “Setting cueup & play (menu)” (page 222).
2 Press the [DEV] button.
The [DEV] button is lit amber, and
the operation
mode switches to device/frame memory/clip player
operation mode.
3 Using the channel selection buttons, select the target
channel (CH1 to CH12) for operation.
You can select multiple channel
s. The first selected
button becomes the reference channel, and is lit
green. Subsequent selected buttons are lit amber.
4 Set the start point.
Play the target device to set usin
g the device control
block and press the [START TC] button at the
position to set as the start point.
5 Set the stop point.
Play the target device to set usin
g the device control
block and press the [STOP TC] button at the position
to set as the stop point.
6 Set loop/recue.
Press the [LOOP] button, turning it on, to set loop. Or
press the [RECUE] button,
turning it on, to set recue.
To set neither loop or recue, set the [LOOP] button
an
d [RECUE] button to the off state.
Loop/recue are only available for di
sk recorders that
use the video disk communications protocol.
7 Save the settings in the register.
For details about save operations using the numeric
key
pad control block, see “Saving an Effect
Timeline” (page 259).
For details about save operations using the menu, see
“Setting cueup & play (menu)” (page 222).
Notes
Note
Note