262
2
Press the [PAUSE] button, turning it on orange.
A pause is set at the selected keyframe.
Setting keyframe loop
You can specify a range on an effect timeline to execute
the range repeatedly.
A loop can be configured at only one locat
ion on an effect
timeline.
1
Select the first edit point (keyframe) for a loop range.
2
Press the [KF LOOP] button, turning it on orange.
“FROM XXX TO” (“XXX” is the current keyframe
nu
mber) is displayed on the display in the numeric
keypad control block.
During loop configuration operations in the numeric
keypa
d control block, the [KF LOOP] button is lit
blue.
3
Enter the number of the last keyframe for the loop
range in the numeric keypad area in the numeric
keypad control block.
To change the number of the
first keyframe in the
loop range, press the [CLR] button. Enter the number
of the first keyframe, press the [ENTER] button, and
then enter the number of the last keyframe.
When the number of the last
keyframe is entered and
you press the [ENTER] button, “COUNT” is
displayed on the display in the numeric keypad
control block.
4
Enter the number of loop repetitions (1 to 99, or 0) in
the numeric keypad area in the numeric keypad
control block.
If “0” is entered, an infinite loop is specified.
5
Press the [ENTER] button.
The loop range and number of repetitions are applied.
• The loop between the specified first
keyframe and
last keyframe is maintained even if a keyframe is
inserted/deleted within the loop range.
• If the first keyframe or last keyf
rame of the loop
range is deleted, the loop is cleared.
Undoing an edit operation
To undo an operation immediately after inserting,
modifying, deleting, or pasting a keyframe, press the
[UNDO] button.
Setting the Duration and Delay
You can set the effect duration, keyframe duration, and
delay to adjust the execution time of an effect timeline.
For details, see “Duration and Delay” (page 254).
Select the target region to se
t and an effect timeline
register, and set the duration mode, duration, and delay.
After configuration, save the effect timeline.
For details about recal
ling an effect timeline register, see
“Recalling an Effect Timeline” (page 258).
For details about saving an eff
ect timeline, see “Saving
an Effect Timeline” (page 259).
You can configure duration and delay by switching the
utility/sho
tbox control block to effect timeline/macro edit
mode.
Setting the duration mode
1
Press the [KF MCRO EDIT] button.
The memory recall section switches to effect
time
line/macro edit mode.
2
Press the [EDIT ENBL] button, turning it on orange.
3
Set the duration mode using the [CONST DUR]
button.
Lit orange: Set
to constant duration mode.
Lit dark blue: Se
t to variable duration mode.
Setting the effect duration
1
Press the [KF MCRO EDIT] button.
The memory recall section switches to effect
time
line/macro edit mode.
2
Press the [EDIT ENBL] button, turning it on orange.
3
Press the [EFF DUR] button.
“DUR XXX:XX:XX” (“XXX:XX:XX
” is the current
effect duration) is displayed on the display in the
numeric keypad control block.
Note
Notes
To Next Page
Loading...
