Sony XVS-G1

269
Setting the duration mode
1 Display the [Effect Timeline Edit] taskbar.
The effect timeline switche
s to edit mode.
2 Press the [All Edit Options] button.
The [Edit Timeline] window appears.
3 Set the duration mode using the [Constant Duration]
button.
On:
Set to constant duration mode.
Off:
Set to variable duration mode.
Setting the effect duration
1 Display the [Effect Timeline Edit] taskbar.
The effect timeline switche
s to edit mode.
2 Press the [All Edit Options] button.
The [Edit Timeline] window appears.
3 Press the [Effect Duration] button.
“DUR XXX:XX:XX” (“XXX:XX:X
X” is the current
effect duration) is displayed on the numeric keypad
area display.
4 Enter an effect duration in the numeric keypad area.
Enter a duration as a timecode
(minut
e:second:frame).
You can also enter a difference value from the
c
urrently set value.
For details, see “Entering a difference from a current
value” (page 77).
5 Press [Enter].
The effect duration is
applied.
Setting the keyframe duration
• In constant duration mode, it is not possible to set the
keyframe duration.
• You can set a default value for the keyframe duration.
For details about settings, see “Setting the default
keyframe duration” (page 415).
1 Display the [Effect Timeline Edit] taskbar.
The effect timeline switches to edit mode.
2 Press the [All Edit Options] button.
The [Edit Timeline] wind
ow appears.
3 Select an edit point (keyframe).
The time from the selected ke
yframe to the following
keyframe is the target to set.
4 Press the [KF Duration] button.
“KF DUR XXX:XX” (“XXX:XX” is the current
key
frame duration) is displayed on the numeric
keypad area display.
5 Enter a keyframe duration in the numeric keypad
area.
Enter a duration as a timecode (second:frame).
You can also enter a difference value from the
currently set
value.
For details, see “Entering a difference from a current
value” (page 77).
6 Press [Enter].
The keyframe duration is applied.
Setting the delay
1 Display the [Effect Timeline Edit] taskbar.
The effect timeline switches to edit mode.
2 Press the [All Edit Options] button.
The [Edit Timeline] wind
ow appears.
3 Press the [Delay] button.
“DELAY XXX:XX” (“XXX:XX” is the current
d
elay) is displayed on the numeric keypad area
display.
4 Enter a delay in the numeric keypad area.
Enter a delay as a timecode (second:frame).
You can also enter a difference value from the
currently set
value.
Note
Notes
Note
Note